ZyXEL Communications AAM1212-51, Руководство пользователя, Страница: 364 / 435

AAM1212-51/53 Series User’s Guide
364 Chapter 52 ADSL Commands
The numbers of milliseconds of interleave delay for downstream and upstream transmissions
are listed. The total output power of the transceiver varies with the length and line quality. The
farther away the subscriber’s DSL modem or router is or the more interference there is on the
line, the higher the power will be. “DS” refers to the power output of the AAM1212 “US”
refers to the power output of the subscriber’s DSL modem or router.
Information obtained prior to training to steady state transition will not be valid or will be old
information.
The
atuc information
fields show data acquired from the ATUC (ADSL Termination
Unit – Central), in this case AAM1212, during negotiation/provisioning message
interchanges.
The
atur information
fields show data acquired from the ATUR (ADSL Termination
Unit – Remote), in this case the subscriber’s DSL modem or router, during negotiation/
provisioning message interchanges. This information can help in identifying the subscriber’s
DSL modem or router.
The vendor ID, vendor version number and product serial number are obtained from vendor
ID fields (see ITU-T G.994.1) or R-MSGS1 (see T1.413).
52.2.4 Lineperf Command
Syntax:
ras> statistics adsl lineperf <portlist>
where
This command shows the line performance counters of a DSL port.
An example is shown next.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
Figure 246 Lineperf Command Example
ras> statistics adsl lineperf 1
[port 1] Perf since boot up
nfebe-I/nfebe-ni : 46/ 0 (Far End CRC)
ncrc-I/ncrc-ni : 5/ 0 (Near End CRC)
nfecc-I/nfecc-ni : 0/ 0 (Far End Corrected FEC)
nfec-I/nfec-ni : 28/ 0 (Near End Corrected FEC)
init-atuc/init-atur: 23/ -
es-atuc /es-atur : 27/ 92
ses-atuc /ses-atur : 26/ 60
uas-atuc /uas-atur : 1515/ 1515
lpr-atuc /lpr-atur : -/ 2