Zubler Vario Press 100, Руководство по эксплуатации

Страница: 9 / 56

Vario Press 100 Operations Manual
VP_0206E 9
10 Ring Forming Papers
Compressed-Air Hose appr. 2 m
Power
The furnace requires 220V-240V and 6.3 Amp. A special heavy-duty power cord has been
supplied with your furnace. DO NOT OPERATE WITH ANY OTHER POWER CORD. DO
NOT OPERATE WITH AN EXTENSION CORD. OPERATING THIS FURNACE ON A
CIRCUIT WITH OTHER FURNACES OR ELECTRICAL APPLIANCES THAT
REQUIRE SIGNIFICANT POWER MAY CAUSE A CIRCUIT BREAKER TO TRIP.
Install the heavy-duty power cord and plug the furnace into a grounded outlet.
Position the furnace so that the front is facing you. You should be able to reach the power switch
on the right side of the furnace at the rear. Be sure to have at least 20cm (8 inches) on all sides of
the furnace to allow sufficient airflow to keep the furnace cool. Do not place anything flammable
near the furnace.
Turn the furnace on using the power switch. The display should light up with a message like the
one shown in illustration 1.0, with the X’s replaced by numbers.
The furnace will perform an internal self test for about 30 seconds and will then display the following
screens:
NOTE : the actual version number of your furnace will replace X.XX.XX in the above illustration.
The PR represents a Vario Press 100.
Front Panel Controls
The front panel controls and their basic functions are described in this section.
Please read this
section carefully. (For further details see the illustration on the following page.)
The front panel controls are divided into four groups:
Ο Menu selection buttons: Run Program, Change Program, and Special Functions
Ο Information entry: Silver Select Knob, Next and Last
Ο Program Start/Abort buttons
Ο
Ο Ο
Ο Table control buttons: Up/Down
VER – X.XX.XX PR
NEXT = CONTINUE
TESTING X X
X XXV XXM XX
Illustration 1.0