Zubler Vario Press 100, Руководство по эксплуатации

Страница: 7 / 56

Vario Press 100 Operations Manual
VP_0206E 7
You are undoubtedly eager to unpack, set up, and begin using your new furnace.
Getting you started will be much easier if you will carefully review the information in
this chapter and follow the steps as outlined.
First
Some things you should know before you unpack your furnace:
When you unpack your furnace, be sure to save the carton and packing materials. These can be
used again if there is ever a need to ship or return equipment.
Be sure to read and save the printed shipping material packed with your furnace – it contains
valuable information!
DO NOT turn on the power to your furnace until you are instructed to do so, or you will damage
your furnace!
Unpacking
If the packaging materials and/or the furnace appear to be damaged, please call your dealer
before continuing
Remove the furnace from the packing materials and place it on a flat surface.
1. Look up into the muffle area and locate the orange shipping bar and wing nuts. Remove the
wing nuts, push the two bolts and attached brackets out of the orange bar. Finally remove the
orange bar by sliding it out the side. Keep these parts incase there is a need to ship the furnace.
Installing the Vacuum Pump
Plug the vacuum pump’s power cord into the outlet end of the short power cord supplied with
the furnace. (Inside the accessory box)
Attach the other end of this short power cord to the international standard outlet on the rear of
the furnace. (next to the furnace power inlet)
Attach a ¼ inch vacuum rated hose from the vacuum pump to the brass fitting marked
“ VACUUM PUMP ” at the rear of the furnace.