Chapter 1: Installation Instructions
15
Establishing Communication
Important!
Macintosh and Linux users must make sure that the computer’s
TCP/IP settings are configured properly BEFORE starting this
section. See
Macintosh TCP/IP Settings
on page 147 or
Linux
TCP/IP Settings
on page 149
for instructions.
You must set up the X6v
so that it can communicate with your
Internet service provider. Follow these steps:
1
Close all programs including antivirus software and pop-up
blockers.
2
Log into the
Zoom Configuration Manager
:
a
Open your Web browser and type
http://192.168.0.1
in
the browser's address field.
b
When the authentication dialog opens, type
user
in the
User Name
field and
password
in the
Password
field, as
shown here.
User Name:
user
Password:
password
Note
: The
User Name
(
user
) and
Password
(
password
)
that you type in this dialog are used by the Zoom
Configuration Manager for non-administrative users and
must be typed as shown, using lower-case characters. (The
User Name
and
Password
for administrative users are
described in
Using Router Setup
on page 86.) These
identifiers are not the user name and password that your
Internet Service Provider might have given you nor are
they names that you choose.
If you are not prompted for a
User Name
and
Password
,
do the following, in this order: Recheck all connections;
restart the modem and computer; then reset the modem
by inserting a paper clip into the
Reset
pinhole in the
modem’s back panel and holding it for at least 3 seconds.
Important:
To protect your configuration, choose your own X6v password
after the setup is complete. See
Changing Your Password
on
page
135
.
Содержание ADSL X6v
Страница 1: ...ZOOM ADSL X6v U S E R G U I D E ...