ZoneVu ZSI-330, Руководство пользователя

Страница: 26 / 30

ZSI-330 User Manual Issue 01 Page 26 of 30
Diagnostics
LEDs
Each serial communications port on the ZSI-330 has LEDs to indicate any Transmit and Receive activity.
The CPU LED maintaining a steady 1Hz flash indicates that the controller has successfully powered up. It
also indicates when configuration mode is active with a faster flash rate.
The Line Status LED indicates the usage of the ISDN line.
•
1Hz flash with the LED on for only a short period indicates the ISDN line is idle
•
1Hz flash with the LED off for only a short period indicates that the ISDN line is connected
•
Fast flash rate indicates that the ZSI-330 is attempting to make a call.
Commands
These commands, which can be issued by Mpower, are included in this document to assist in the diagnosis
of problems.
The use of these commands is at the users own risk and is subject to change without notice.
Fn Name Purpose Notes
0 Initialise Initialise all modules
1 LoadDefaultConfiguration Reset configuration. All static configuration is set to factory defaults
2 StandaloneTestMode For factory use only
3 InitialiseCmdHandler Re-initialise command stack.
Discards all current commands. May cause memory loss. For
debugging only
4 FlushCommandStack
Clear all commands from the
stack
Discards all current commands. Will stop CPU LED flashing.
5 InitialiseBothOSD Re-initialise the display chips
6 ScreenModeInternalSync
Sets the display to internal
sync
Video input will no longer be displayed
7 ScreenModeTranslucent Selects translucent text mode
8 ScreenModeOpaque Selects opaque text mode
9 InitialiseMonitor
Reselect the current camera or
sequence
10 ReInitialisePC2Port
Re-initialise internal control
port
Resets uart & discards commands
11 ReInitialisePC3Port Re-initialise clear data channel Resets uart & discards commands
12 ReInitialiseZvmPort Re-initialise ZoneVu port.
Resets uart & discards commands. Required after changes to
comms settings.
13 ReInitialiseZvrPort Re-initialise ZVR port.
Resets uart & discards commands. Required after changes to
comms settings.
14 InitialiseMMT Initialise 8121 board Reloads all configuration into 8121, after power-up delay
15 InitialiseDialup Initialise call status Assumes call status is idle
16 InitialiseContactAlarms
Reset the status of alarm
inputs
17 InitialiseControl Reset camera control records Assumes no camera control held. Restarts control timeout.
18 FlushAlarmQueue Remove all alarms from queue No notification is sent to keyboards
19 InitialiseAlarms Re-initialises alarm module Discards all alarms. May cause memory loss – for debugging only.
20 RestartApplication Re-starts application Simulates power-up
21 RestartMMT Re-starts 8121 board Uses serial command to simulate power-up reset.
22 InitialiseTelemetry Re-initialise telemetry module Clear receiver alarm status & latched function log.
MEYERTECH LIMITED
Z
S
I
-
3
3
0