Zonar V3, Руководство пользователя и инструкция по установке, Страница: 15 / 28

GPS VM (Vehicle Mount) and 2010
1) Follow all General Guidelines as specified on page 7.
2) Mount onto interior flat surface large enough to accommodate
footprint.
3) Do not install below windows or doors which open to the
vehicles exterior to prevent water damage.
4) Avoid mounting equipment in difficult to access areas.
5) Avoid mounting equipment in dirty, dusty, or damp areas (e.g.
near floors and entrance ways).
6) Mount vertically to ensure good electrical connection between
2010 and VM.
7) Ensure 2010 unit can be easily inserted / removed without
interference.
8) Mount high in vehicle; avoid driver’s leg and arm rest areas.
This also minimizes the chance of the mount being used as
a holder for non Zonar equipment.(e.g. glasses, pens, pencils,
etc.).
9) Retention (Adhesive or Screw):
A) Adhesive install part number 80133: Clean and dry the
surface before placing the mounting plate. To obtain
optimum adhesion, the surface must be clean and dry.
The best surface cleaning solvent is an isopropyl
alcohol/water mixture (rubbing alcohol). Remove the backing
from the peel and stick. Press and hold mounting position
for 10 seconds to assure good adhesion.
Note: Adhesive optional (not included in order). Use red
rectangular adhesive if you deem necessary.
B) Screw install: Only use Zonar supplied hardware . Use
of non Zonar screws generally leads to interference issues
and scratching of the 2010 unit. Use preventative measures
to capture & remove metallic chips that are created during
the installation of self-tapping screws. Metallic chips may
short the contact pins inside the Vehicle Mount (VM) that
mate with the contact pins of the 2010.
Capture – Insert clean paper towel or clean shop towel
dam inside VM when installing self-tapping screws. Carefully
remove temporary dam to minimize the possibility of
dropping metallic chips into the Vehicle Mount (VM).
Chip removal – After dam removal, follow-up with stick
magnet (must be electrically insulated to prevent shorting
pins), compressed canned air, or mini-vac to ensure no
chips remain.
10) Drill, deburr and grommet cable thru hole as required.
Tags
1) Please refer to the Tag Location Installation Guide for tag number
to vehicle zone information. If you cannot locate this document,
please call Zonar Support toll free1-877-843-3847
2) Whenever possible, avoid installing tags in cold/wet/damp conditions.
Ideal application range is: 70˚F to 100˚F (21˚C to 38˚C)
3) Clean and dry the surface prior to placement. To obtain optimum
adhesion, the surface must be clean and dry. The best surface
cleaning solvent is an isopropyl alcohol/water mixture (rubbing
alcohol). Remove the backing from the peel and stick. Press and
hold mounting position for 10 seconds to assure good adhesion.
4) Consistency between vehicles is key to a professional installation.
If you or the customer are unsure where to place any tag, call a
Zonar Customer Service Representative for assistance prior to
installation.
5) Minimum spacing between tags is 3” to reduce the likelihood
of read interference
GPS VM & TAG
INSTALLATION
15
55501245
Single and double digit tags
(e.g., 1, 5, 11) are location
specific.
Tags greater than 2 digits
(e.g., 55501245) are
vehicle and location
specific
ZONE
03