ZOLL thermogard xp, Руководство по эксплуатации

Страница: 104 / 147

Accesories - HMIA
10
14. Power ON the System.
15. Verify that the Green LED of the HMIA is ON.
16. Connect a TP-400 temperature simulator to the T1 connection on the
front of the System. Set to 35
O
C.
17. Using an air trap test fixture to complete the set-up procedure,place the
System in STAND-BY.
18. Verify that the patient temperature displayed by the System is also
displayed on the hospital m/- 0.1
O
C.
Note:
There may be a delay, as long as 2 minutes, before the temperature displayed
by the hospital monitor agrees, /- 0.1
O
C, with the temperature
displayed by the System.
19. Set the TP-400 to 38
O
C.
20. Verify that the patient temperature displayed on the System screen is
also displayed on the hospital m/- 0.1
O
C.
21. Remove the TP-400 and verify that the hospital monitor recognizes the
loss of patient temperature. Typically the hospital monitor will indicate
that the probe is DISCONNECTED.
22. Reconnect the TP-400
23. Verify that the patient temperature displayed on the System screen is
also displayed on the hospital m/- 0.1
O
C.
24. Power OFF the System.
25. Verify that the hospital monitor recognizes the lack of input. Typically the
hospital monitor will indicate that the probe is DISLODGED.
26. The System with the HMIA module is now available for clinical use.
Removal of the HMIA
To remove the HMIA, simply apply the installation instructions in reverse
beginning with step 12.
Connection Cable Part Numbers
The following connection cables are available to allow the connection of the
HMIA to your hospital monitor. If you have another type of connector or do not
know which connector to use, please contact ZOLL Customer Service.
Table 2 Connection Cable Part Numbers
Part
Number
Connects to
500628-001 Monitors using a 3.5mm phone jack (Bard
®
)
500629-001 Monitors using a 2.5mm phone jack (Terumo
®
)
500630-001 Monitors using a 2-pin Molex type connector with socket contacts (Mallinckrodt
®
or
Smiths Medical
®
)
500631-001 Monitors using a 2-pin Molex type connector with pin contacts (Rüsch
®
)
600479-001 Rev 2 104/147