ZOJE ZJ2842-BD, Руководство по эксплуатации

Страница: 45 / 76

32
<L >
1
2
<R >
1.
2.
3.
4.
7mm ( )
5.
6.
( 28 )
1. Loosen the nut and then loosen the presser foot
adjustment screw .
2. Open the face plate.
3. Raise the presser foot
with the presser foot lifter .
4. Loosen the screw and then move the needle bar
up oe down to adjust so that the presser foot is
approximately 7mm above the top of the needle plate.
Note: Be careful not to rotate the needle bar .
5. Tighten the screw .
6. Adjust the presser foot pressure by turning the presser
foot adjustment screw ,and than tighten the nut .
(Refer to page28)
1.
2.
3.
4.
7mm ( )
5.
6.
( 28 )
1. Loosen the nut and then loosen the presser foot
adjustment screw .
2. Open the face plate.
3. Raise the presser foot
with the presser foot lifter .
4. Loosen the screw and then move the needle bar
up oe down to adjust so that the presser foot is
approximately 7mm above the top of the needle plate.
Note: Be careful not to rotate the needle bar .
5. Tighten the screw .
6. Adjust the presser foot pressure by turning the presser
foot adjustment screw ,and than tighten the nut .
(Refer to page28)
0.147
-0.343 (15-35 )( )
1.
2.
3.
4.
( )
1.
2.
3.
0.147
-0.343 (15-35 )( )
1.
2.
3.
4.
( )
1.
2.
3.
2
1
5
3
4
6
7 mm
0.147-0.343
(15-35
gl )
1
5
6
7
Less Less
More More
Less Less
More More
9
8
2
6
Thread take-up spring tension
The standard tension for thread take-up spring L
andthread take-up spring R
is 0.147-0.343N(15-
35g)for both spring.(Thread take-up spring L )
1. Open the face plate.
2. Loosen the screw
.
3. Loosen the knob ,and then rum the thread
tension stud to adjust the tension.
4. Tighten the screw ,and then tighten the knob .
(Thread take-up sprig R )
1. Loosen the set screw .
2. Loosen the knob and then turn the adjustment
knob to adjustthetension.
3. Tighten the screw , andthentightenthe knob .
Thread take-up spring tension
The standard tension for thread take-up spring L
andthread take-up spring R
is 0.147-0.343N(15-
35g)for both spring.(Thread take-up spring L )
1. Open the face plate.
2. Loosen the screw
.
3. Loosen the knob ,and then rum the thread
tension stud to adjust the tension.
4. Tighten the screw ,and then tighten the knob .
(Thread take-up sprig R )
1. Loosen the set screw .
2. Loosen the knob and then turn the adjustment
knob to adjustthetension.
3. Tighten the screw , andthentightenthe knob .