ZOJE ZJ1900DSS, Руководство пользователя

Страница: 131 / 146

COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
- 60 -
［
5
］
Position of the button clamp jaw lever
.
⑴
Press key in the state that the
swing LED goes off using the operation
panel.
. ⑵
⑶.
⑷.
Place a button in button clamp jaw
levers
①
.
⑸.
⑹
. Turn the hand pulley and check that
the center of the needle enters the center of
the button.
⑺
. If the center of the needle is not located
in the center of the button, loosen screws
②
in the button clamp jaw lever base to
adjust so that the center of the needle enters
the center of the button.
⑻
. After the adjustment, perform the
confirmation of the pattern shape and make
sure that the needle surely has entered the
button hole.
WARNING: When change of the shape of button , change of the sewing pattern or
enlargement/reduction of the sewing width is performed, make sure the needle
entry point. If the needle extends outside the button hole or the sewing pattern
extends outside the button clamp unit, the needle interferes with the button hole or
the button clamp unit, resulting in the danger of the needle breakage or the like.
Press key at the same
Press the key twice to enter the CP
time, press the key to enter the
debug mode, the screen shows CP ---.
mode.
Press key to enter CP-2, press
key, then press key, step on the pedal
to a file.