ZOJE ZJ1900DSS, Руководство пользователя

Страница: 132 / 146

COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
- 61 -
［ 6 ］
Adjusting the feed plate
［ 7 ］
Adjusting the button clamp jaw lever
⑴
.in the state that the LED light off, press the key
operation panel, choose winder state,
light on.
⑵
.press key, the button clamp unit goes to
the original position and goes down
。
⑶
. adjust the feed plate
①
, so the needle hole guide
②
comes to the center of the recessed part of feed
plate
①
H.
⑷
. press key, button clamp goes up
，
start sewing.
WARNING: When change of the shape of the button, change of the sewing pattern or
enlargement/reduction of the sewing width is performed, make sure of the
shape of the sewing pattern. If the feed plate interferes with the needle hole
guide, it will result in the danger of the needle breakage or the like. Also, if
the pedal is depressed during the adjustment, the button clamp unit will
go up or come down. So, be careful.
Turn OFF the power before starting the work so as to prevent accidents
cause by abrupt start of the sewing machine.
Bring the machine to its stop-motion
state. Then lift button clamp
①
. Loosen
screw
②
in the button clamp jaw lever
and adjust so that a clearance of 0.5 to
1mm is provided between button clamp
jaw lever
③
and hinge screw
④
when
placing a button in between button
clamps
①
. Then tighten screw
②
in the
button clamp jaw lever.