COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
ii
Danger of injury to operator or service staff
Items requiring special attention
FOR SAFE OPERATION
1. To avoid electrical shock hazards, neither open the cover of the electrical box for the motor nor touch the
components mounted inside the electrical box.
2. After changing the pattern, make sure the needle entry point. If the pattern is protruded from the work
clamp feet, the needle will interfere with the work clamp feet during sewing, and it is dangerous due to the
needle breakage or the like.
3. Do not turn OFF the power in a state that the needle is lowered. Wiper may break the needle.
1. When nothing is displayed in the operation panel even when the power switch is turned ON, turn OFF the
power switch and check the voltage and the type of the power source.
2. So as to prevent possible accidents caused by abrupt start of the sewing machine, depress the start switch
after ascertaining that there is no interfering thing under the needle when windi
ng the bobbin thread.
3. When turning OFF the power switch, turning ON the ready switch or turning ON the work clamp foot
switch, the work clamp feet automatically come down. So, never place your fingers under the work clamp
feet to prevent possible accidents caused by abrupt start of the sewing machine. During operation, be
careful not to allow your fingers to come close to the work clamp feet.
4. So as to prevent possible accidents caused by the touch of the fingers with the needle, install a finger guard
suitable for each work clamp foot when replacing the work clamp foot.
1
•
There is the possibility that slight to serious injury or death may be
caused.
•
There is the possibility that injury may be caused by touching moving
part.
2
•
To perform sewing work with safety guard.
•
To perform sewing work with safety cover.
•
To perform sewing work with safety protection device.
3
•
Turn OFF the power and perform “threading”, “replacement of
bobbin or needle”, “cleaning”, “adjustment” and “lubrication”.
In general, during working time, in order to protect against drawing in or trapping and entanglement hazards, client
will provide working clothes and hats which are tight with operators, if not , clients must rule operators wear tight
clothes and operators with long hair must tie up or wear hat to prevent hazards.
Содержание ZJ1900DSS
