Zoeller ProPak AQUANOT FIT 508/63 Скачать руководство пользователя страница 2

Страница: 2 / 12

The DC controller is equipped with a charger for maintaining the battery
in a ready state and recharging the battery after use when AC power is
restored. Time for recharge depends upon the amount of power consumed
by the pumping cycle during the AC power interruption. The pump may go
back to the ready run position in a very short period of time. A completely

drained battery may require up to 24 hours for full recharge. If battery does

not charge properly, the battery LED will flash red.

LIMITED WARRANTY

PERFORMANCE

The DC pump performance at 12.7 Vdc

BATTERY SELECTION

Manufacturer warrants, to the purchaser and subsequent owner during the

warranty period, every new product to be free from defects in material and

workmanship under normal use and service, when properly used and maintained,

for a period of 3 years (models 508/53 and 508/98) or 5 years (508/63) from date

of purchase by the end user. Zoeller batteries have a 3 year warranty. Proof of

purchase is required. Parts that fail within the warranty period, that inspections

determine to be defective in material or workmanship, will be repaired, replaced or

remanufactured at Manufacturer's option, provided however, that by so doing we

will not be obligated to replace an entire assembly, the entire mechanism or the

complete unit. No allowance will be made for shipping charges, damages, labor

or other charges that may occur due to product failure, repair or replacement.

This warranty does not apply to and there shall be no warranty for any material

or product that has been disassembled without prior approval of Manufacturer,

subjected to misuse, misapplication, neglect, alteration, accident or uncontrollable

act of nature; that has not been installed, operated or maintained in accordance

with Manufacturer's installation instructions; that has been exposed to outside

substances including but not limited to the following: sand, gravel, cement, mud,

tar, hydrocarbons, hydrocarbon derivatives (oil, gasoline, solvents, etc.), or other

abrasive or corrosive substances, wash towels or feminine sanitary products,

etc. in all pumping applications. The warranty set out in the paragraph above is

in lieu of all other warranties expressed or implied; and we do not authorize any

representative or other person to assume for us any other liability in connection

with our products.

Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky 40211, Attention:

Customer Support Department to obtain any needed repair or replacement of

part(s) or additional information pertaining to our warranty.

MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPECIAL, CONSEQUENTIAL

OR INCIDENTAL DAMAGES OR BREACH OF EXPRESSED OR IMPLIED WARRANTY;

AND ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND

OF MERCHANTABILITY SHALL BE LIMITED TO THE DURATION OF THE EXPRESSED

WARRANTY.

Some states do not allow limitations on the duration of an implied warranty, so

the above limitation may not apply to you. Some states do not allow the exclusion

or limitation of incidental or consequential damages, so the above limitation or

exclusion may not apply to you.

This warranty gives you specific legal rights and you may also have other rights

which vary from state to state.

Discharge

Feet of Head

(1.5 m)

(3 m)

(4.6 m)

(85 m)

Flow

GPM (LPM)12.7 volts

(163)

(132)

(102)

Shut-off

Head

This system is a combination of a primary sump pump and a backup pump to your primary sump pump. It is designed to protect against flooding during power

outages or primary pump failure. This system is unique in that it has self-testing and communication features when connected to the Z Control Cloud. The pump

is self-priming and specifically designed and manufactured by Zoeller as a purpose-built DC sump pump, rather than a repurposed bilge pump. The controller

has smart diagnostics built in. If the DC pump is unplugged or jammed, for example, a fault alarm will result. If either float switch is missing/unplugged, it will

create an immediate alarm condition. The controller will recognize the difference between a pump that is pumping air vs. a pump that is pumping water. This

will lead to behaviors designed to purge air and remedy an air lock situation. The controller also has smart float logic that is designed to prevent a continuous

running pump (or run dry pump condition). Zoeller uses a normally open operational float switch, and a normally closed high water float switch. The advanced

technology hardware and firmware in the Fit controller will recognize, attempt to remedy, and alarm for many conditions that have not previously been possible.

The controller will automatically charge and maintain the battery in a way designed to extend battery life.

DESCRIPTION

The DC emergency pump system requires a good quality, 12 volt battery
to obtain maximum pumping time during a power outage. A deep-cycle, 12
volt, 90 amp-hour or larger marine battery is recommended. A 100+ amp

hour battery will provide approximately 5.5 hours or more of continuous
pumping time in a sump pump installation with 8' (2.4 m) of head pressure.
In most installations, the pump runs intermittently and the battery life is
extended accordingly. Batteries with top terminals are recommended for
ease of installation. "Wet" cell batteries contain acid, and proper precaution
must be taken when handling. Battery box will accommodate a maximum
battery size of 13-1/2" (34.3 cm) Length x 7" (17.8 cm) Width x 9-1/2" (24.1

cm) Height. AGM batteries also recommended. Do not use gel batteries

or automotive batteries.

Primary

Pump

Construction

Cast iron & plastic, premium seals

Performance

53: 34 GPM 98: 61 GPM

63: 34 GPM measured @ 10' head

DC Pump

Construction

Non-corrodible plastic, premium seals