7
1.3 I Operating principle
The cleaner is independent of the filtration system and can, once charged, operate autonomously. It finds the best route
to move around and clean the areas of the pool for which it has been designed (floor, walls, waterline or floor only).
Debris is sucked in and stored in the cleaner's filter.
The cleaner can be used:
- By selecting an operating mode and starting a cycle with the cursor on the rear of the cleaner, or
- Via a smartphone or a tablet compatible with the iAquaLink™ app (see "❸ Using the iAquaLink™ app").
3.5 meters
minimum
: Charging station
: Plug
: Cleaner
: “iAquaLink™”
remote control
1.4 I Pool preparation
•
This product is intended to be used in pools which are permanently installed. Do not use it in pools
which may be dismantled. A permanent pool is built into the ground or on the ground and cannot be easily
dismantled and stored.
•
The appliance must operate in pool water with the following properties:
Water temperature
Between 10°C and 35°C
pH
Between 6.8 and 7.6
Free chlorine
< 3 mg/ l
•
When the pool is especially dirty, especially when commissioning, remove the largest debris using a net in order to
optimise the appliance's performances.
•
Remove any thermometers, toys and other objects that might damage the appliance.
EN
