Zodiac Transport 160, Руководство пользователя

Страница: 60 / 74

EN
GLIS
H
60
¢
Receiving
The green LED lamp flashes when the channel
being called.Then you can hear the calling from
the transmitting party.If the transceiver has set
with higher squelch level, it may fail to hear the calling.
If the green lamp keep lighting, it means the transceiver
is receiving a matching carrier and un-matching signaling.
The calling is not audible.
( Please refer to signaling combination setup).
¢
Squelch / Monitor
Squelch:
The purpose of squelch is to mute the speaker when no signals are present.
You can adjust the squelch level by keep pressing
SQ/M
key,and then turn
the On/Off/Selector knob.
If the transceiver has set at a higher squelch level, it may fail to hear the calling;
If set a lower squelch level, the transceiver will be easily interfered.
Monitor:
This function enable you to monitor weak signal.
key can be set as Squelch Off/Squelch Off Momentary function, this function enable you to
monitor weak signal.
1.
Squelch Off: Press
SQ/M
to disable squelch,
background noise appears.
Press
SQ/M
key again to resume squelch.
2.
Squelch Off Momentary:
Press and hold
SQ/M
to disable squelch,
background noise appears.
Press
SQ/M
key again to resume squelch.
¢
Channel Scan
T
his function is designed to monitor signal in every channel.
Press
SCAN
key or
P1
/
P2
programmed as scan to start scanning, press again to stop
scanning.
Priority Scan
This transceiver can be set with two priority channels.
Users can setup desired channel by programming software.
If transceiver set priority scan, under scanning
and unreceiving signal state, it will scan per
channel and also test priority channel at a time.
When the nonpriority channel receives signal,
it will test priority channel according to flyback time A
and flyback time B setup by users.
(Use programming software to setup).
Busy lamp (green)
On/Off/Selector
Squelch
Scan