Zodiac iAquaLink Z400iQ, Инструкция по установке и эксплуатации

Страница: 14 / 33

12
2.2.2 Description of the display screen
Symbol Name Steady Flashing Off
Water flow Water flow okay
Water flow too low or
missing
Appliance switched off
Air temperature /
Air temperature out of
operating range
Air temperature in the
operating range
“Cold” mode “Cold" mode activated /
"Cold" mode
desactivated
"Silence" mode
"Silence" mode
activated
/
"Silence" mode
desactivated
Wi-Fi Wi-Fi connected
Wi-Fi pairing in
progress
Wi-Fi not connected
2.2.3 Description of the LEDs showing the «appliance status»
LED Appliance status Meaning
Steady green
OK Temperature reached or operation in "hot" mode
Steady blue
OK Operation in "cold" mode
Steady red
Error in progress
Error in progress, see error message on the interface and meaning
(see § ‘’4.2 I Error code display’’)
Flashing red
Stopped
The appliance shuts down after more than 4 errors in one hour and
requires a manual restart after correcting the error (see § ‘’4.2 I Error
code display’’)
Off
Stopped Device off or not connected to the power supply
2.3 I Operation
• Check that there are no tools or other foreign objects in the machine.
• The panel that provides access to the technical section (see § «5.3 I Dimensions and marking») must be put back in
place.
• Set the valves as follows: valve B wide open, valves A, C, D and E closed.
: water inlet valve
: by-pass valve
: water outlet
valve
: water inlet adjustment valve (optional)
: water outlet adjustment valve (optional)
• An incorrect by-pass setting may cause the heat pump to malfunction.
• Check that the hydraulic connections are correctly tightened and that there are no leaks.
• Check that the appliance is stable.
• Turn on the water flow (by activating filtration).
• Close valve B gradually so that the filter pressure is increased by 150g (0.150 bars).
• Open valves A, C and D fully then valve E by half (the air which has built up in the heat pump condenser and the
filtration circuit will bleed out). If valves D and E are not present, open valve A wide and close valve C by half.
• Connect the power supply to the heat pump.
EN