8
Operation:
Standard operation for both 9300 & 9300xi
• Select Cycle:
- Cycle I is 1.5 Hours and
concentrates on the bottom of
the pool.
- Cycle II is 2.5 Hours and
allows for both the bottom
and walls of the pool.
• The cleaner will move forward and backward and periodically
turn left and right during the cycle. Debris will be captured in
the filter canister.
• Upon completion of the cycle, the light on the power pack will
flash for 15 minutes and then go out completely.
Note: To turn the cleaner off mid cycle, press the power button,
.
9300 Power Pack Shown
Operation:
Automatic Start Mode (9300xi only)
The 9300xi has an Automatic Start Mode
application if you GFCI outlet is hooked up to a
time clock or relay from a control system. This
will allow the cleaner to automatically start
when power is supplied to the power pack.
1- Decide which cycle you would like to run.
Note:
This feature will run for 2.5 hours in both Cycle I and Cycle II. Cycle I
will concentrate on the floor of the pool while Cycle II will go over the whole
pool including the walls.
2- Hold the timer button,
,and the cycle button of choice down for 3+
seconds. The 2 lights on either side of the timer button will flash once
indicating the timer mode is activated. Now the cleaner will come on
whenever power is applied to the power pack.
To cancel the timer mode:
1- Turn on power to the power pack.
2- Hold the power button, ,down for 6+ seconds. The two lights on either
side of the power button will blink once indicating the timer mode is
deactivated.
9300xi Power Pack Shown
OPERATION
