27
Troubleshooting:
Flashing Cycle Lights
Note: The Program lights will flash
if the cleaner pulls air for
approximately 1 minute. Before
proceeding to the following steps,
make certain that all of the air has
been expelled and that the cleaner
is fully submerged.
Flashing cycle lights are an indicator of one or more of the
following:
• Flow obstructions in the cleaner
• Dirty canister filter
• Trapped air in the body of the cleaner
• Poor cable connection at the motor block
• Short circuit of the motor or PCB
• Floating cable problem
• Software bug in the power pack
9300 Power Pack Shown
Troubleshooting:
Flashing Cycle Lights
Step 1:
•
Check for debris clogging the brushes or propeller. Remove obstruction
and test the cleaner.
•
Check the canister for fine debris. Try running the cleaner without the
canister for a short period, 15 to 20 minutes, to see if the problem
persists. If the problem does not return, the cleaner is picking up very
fine sediment and/or algae. Clean the canister more frequently or
vacuum the pool if necessary before operating the cleaner again.
If problem persists, continue to step 2.
TROUBLESHOOTING
