ZLP Electronics DigiMaster Pro3, Руководство пользователя

Страница: 6 / 30

The 4 devices are;-
[a] Generic USB Hub.
[b] USB audio CODEC.
[c] 3 USB serial Ports. (Yours will most likely have different com numbers assigned and you may also
have comports already installed and so you may see more entries).
The interface is installed.
Now turn the interface OFF and the entries will disappear.
Turn the interface ON and they will reappear.
Make a note of which com[x] (comports) disappear and reappear when you turn the interface off and
back on, they are the ones you will need to know when you configure your software.
You may also have other USB audio CODECS, if so; Windows will number them, make a note of the
one that disappears and reappears (and any number it may have been given) when you turn the
interface off and back on. You will also need this to correctly configure your software.
The hardware is installed and you know the ports and the soundcard to use when configuring your
software.
Testing the interface.
REMOVE ALL LEADS FROM THE INTERFACE EXCEPT THE USB LEAD.
Turn the interface ON.
Windows will ALWAYS test comports whenever you power up the interface.
Several LED’s will illuminate and some will flicker several times.
The GREEN power LED will illuminate.
The GREEN/RED Rx/Tx LED will illuminate and turn RED several times.
You should now download and run the DigiMaster test program.
When the program run’s, it will find and test any (and all) comports on your PC.
When it finds the DigiMaster Pro3 ports it will test them and it will also obtain information from them.
The information will tell you which comport is used for the CAT interface.
The DigiMaster Pro3 has three comports; the first is used to control the DATA section of the Pro3.
(PTT and FSK-via TXd). The second comport is used exclusively for the CAT interface. The third is
used for the CW keyer.