Zirkon zahn P4000 PRINTER, Руководство по эксплуатации и обслуживанию

Страница: 45 / 80

01 02
03
45
CHAPTER
CLEANING
ZIRKONZAHN – P4000 PRINTER OPERATION AND MAINTENANCE MANUAL – VERSION: 20/09/2022
CLEANING THE EXTERIOR
%JGEMVJGGZVGTKQTQHVJGRTKPVGTHQTCP[VTCEGUQHTGUKP7UGCUOCNNCOQWPVQHUCPKVKUKPI
alcohol to remove the resin, if necessary.
HOW TO REMOVE CURED RESIN FROM THE LCD
ATTENTION: Resin spillages on the LCD might cause permanent damages to the LCD.
In such cases, remove the resin carefully according to the following instructions.
Apply a small amount of 95% sanitising alcohol on
the spillage and wait 5/10 minutes (add alcohol
halfway to avoid that it dries out).
Detach the cured resin using a playing card or a
plastic scraper.
ATTENTION: It is important that the LCD display is clean,
otherwise the resin cannot be cured properly, causing poor
results.
Repeat these two steps till the cured resin has been
removed completely.