Zirkon zahn P4000 PRINTER, Руководство по эксплуатации и обслуживанию

Страница: 40 / 80

01
03
02
04
40
CHAPTER
OPERATION
ZIRKONZAHN – P4000 PRINTER OPERATION AND MAINTENANCE MANUAL – VERSION: 20/09/2022
How to Remove Printed Objects
ATTENTION: Wear gloves! Contact with printing resin might cause skin irritations.
Prints that are Hard to Remove
+HVJGTGOQXCNQHVJGOQFGNHTQOVJGDWKNFKPIRNCVGKURCTVKEWNCTN[FKHſEWNVYGUWIIGUVVQ
01. Use a utility knife to detach one corner of the print, paying particular attention to not to
scratch the surface of the building plate, then use the metal scraper to detach the rest.
02. Warm up the building plate using a heat gun or by soaking the plate in warm/hot water
( ATTENTION! Soaking is possible for water-washable resins only).
When heating the building plate, make sure that the temperature does not exceed the resin’s
TG temperature.
Preventing Prints from being too Hard to Remove
+H[QWPQVKEGVJCVRTKPVGFQDLGEVUQXGTCFJGTGVQVJGDWKNFKPIRNCVGCPFKVKURCTVKEWNCTN[FKHſEWNVVQ
remove them from the plate, reduce the exposure time of the prints' bottom layer.
Place the building plate carefully on a clean, fl at and
stable surface.
Remove the model without putting pressure on it,
which might cause distortions on the object.
Slide the metal scraper under the model with the
smoothed edge facing upwards.
Check for any traces of cured resin on the
building plate.