Zippkits Tugster, Инструкция по сборке

Страница: 8 / 25

8
Be sure that all bulkheads are fully seated and
again check that all are square to the hull side.
Turn your square 90 degrees and check that all
bulkheads are square to the bench.
Glue in doubler 3A in FRONT (motor side) of
BH 3.
Glue in doubler 4A in FRONT of BH 4.
Glue in the ends. These are marked Outer.
Put the hull upside down on your bench on wax
paper and glue all bulkheads to the other hull
side.
Glue in the fwd and aft bulkhead doublers.
These are marked “inner”.
Allow to cure.
Step back and admire your new tug. That was
no work at all. Just fun…
Let’s get ready to put the bottom in place.