Zippkits Tugster, Инструкция по сборке

Страница: 7 / 25

7
Hull
The hull sides are laminated from 2 pieces of
ply.
The inner piece has the slots for the bulkheads.
The inner piece is also shorter than the outer.
This allows you to glue the end pieces (marked
“outer”) into a strong joint.
We used medium CA glue for all assembly. You
can also use epoxy or any water proof glue.
Glue the inner hull to the outer hull, leaving 1/8
inch on each end.
Be sure to make a right and left side. The best
way to do this is to make mirror images of the
sides as shown.
Be sure that you make a right and left side.
Weight or clamp until cured.
Bulkheads
Test fit the bulkheads in place. They will only fit
in their respective slots.
Use the large square provided so that these are
90 degrees to the hull sides.
Bulkheads 1, 2 and 6 are the same. Glue these
in place on one of the hull sides.
Use the square and be sure all bulkheads are
square in 2 planes as shown. Get the bulkheads
square side to side as well as front to back.
Glue the rest of the bulkheads in place using the
square provided.