Zippkits Tugster, Инструкция по сборке

Страница: 21 / 25

21
Slide the motor coupler assembly onto the
motor shaft so that it is about 1/4 inch from
touching the motor.
Lightly oil the prop shaft and wipe off excess oil.
Slide the propshaft into the shaft tube, and into
the motor coupler.
Leave a tiny gap between the prop and shaft
tube.
Tighten both set screws until they are just snug.
Do not over tighten…
Radio
Assemble the rudder and keel shoe.
Put the rudder steering arm on the rudder shaft
so that it is touching the rudder tube.
Install your rudder servo.
Leave a gap towards the front of the servo so
that the wire can exit.
Install the EZ connector onto your servo arm.
Put the .050 music wire “Z” bend into the rudder
steering arm and slip the other end into the EZ
connector.
Don’t tighten anything yet.
Use two sided tape to attach the ESC
(Electronic Speed Control) to the radio tray on
the starboard side.
Mount the radio receiver the same way on the
port side.
Attach the motor leads to the ESC.
Plug in the ESC and rudder servo to the
receiver. Rudder is usually channel 1 and ESC
channel 2.