Zippkits Tugster, Инструкция по сборке

Страница: 11 / 25

11
Keel
The keel is laminated from 4 pieces, leaving a
groove all the way through.
Grab one of the keel sides and glue inner keel A
to it.
Glue inner keel B above it, leaving a 1/8 inch
gap.
Be sure to match the inner keel outline to the
outer.
Glue the other keel side over the inner keels,
again matching the outline.
Allow to cure.
Drill out the slot with a 5/32 drill bit.
Run the drill in and out of the keel a few times to
make a nice round slot.
Deck
The deck has 5 parts. 4 of them form a lip that
the hatch fits on.
Glue the long strips in place first.
Use your square and make sure they are flat on
the bench, and flush with the bottom of the
deck.
Glue the 2 short end pieces in place. These go
between the long ones. Use your square.