ASSEMBLY
30
ZI-GPS252
12
ASSEMBLY
12.1
Check delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or missing
parts to your dealer or the shipping company immediately. Visible transport damage must also be noted
immediately on the delivery note in accordance with the provisions of the warranty, otherwise the goods
are deemed to have been properly accepted.
12.2
Assembly
1.
Assemble the cutting units or extension
•
Pull out the locking pin (1) and fully insert the
cutting unit (2) until the locking pin (1) engages
in the hole (3). To do this, it is advisable to turn
the cutting unit (2) slightly in both directions.
•
The locking pin (1) is in correct position when it
is fully engaged in the hole (3).
•
Tighten the rotary knob (4) firmly after insert-
ing the selected cutting unit (2).
Boom (extension):
•
The boom (extension) can be installed be-
tween the motor unit and the respective cut-
ting unit. It is installed in the same way as the
cutting unit.
2.
Assemble the round handle
•
Align the lower handle (2), the bracket (1) and
the round handle (3) on the boom and tighten
the wing screw (4) until the round handle is
fixed.
3.
Assemble the harness
•
Please put the harness on as illustrated below. To adjust the belt, pull it so that it fits as described
below.
•
You can change the harness height through the adjuster, as illustrated below, and then attach
the harness to the machine using the hook.
4.
Assemble the blade guard (trimmer)
•
Fix the blade guard (1) to the cutting unit (trim-
mer) (2) with two screws (3) and tighten them.
