6
808081 v1.01 06.21 Industrial Tap Instructions
1
Top Touch Tap Font Installation
Font Installation (optional)
Industrial Top
Touch Tap
Black plastic
spacer
Font
Spacer ring
under Font
Benchtop
Steel washer
Spider clamp
Fixing nut
• Position the Font template (provided
in the kit) on the bench, so that the
Command Centre is within reach of the
tap hoses and USB cable.
• Cut the holes as shown in the template.
• Apply a light smearing of silicone
sealant on the underside of the spacer
under the Font. Locate the spacer
under the Font base.
• Pass the tubes and USB cable through
the hole and use a tube spanner to
secure the tap in place.
• Position the Font template (provided
in the kit) on the bench, so that the
Command Centre is within reach of the
tap hoses and USB cable.
• Cut the holes as shown in the template.
• Apply a light smearing of silicone sealant
on the underside of the spacer under the
Font. Locate the spacer under the Font
base.
• From below the bench, feed the three
tubes and USB cable through the clamp
block, noting the orientation marker.
• Fit the 3 cap screws and spring
washers. Tighten with an allen key.
• Use a tube spanner to secure the fixing nut.
2
Side Touch Tap Font installation
Industrial Side
Touch Tap -
Tapered base
O-ring seal
Font
Spacer ring
under font
Benchtop
Clamp block
Spring washer
Fixing nut
Cap screws x3
