Page 14 of 20
HydroTap Installation and Operating Instructions
Warning:
If the HydroTap is switched off for a long period of time (e.g.
more than a weekend), run water through the chilled water outlet for at least
5 minutes before consumption.
Blue Chilled Water Light
On all the time:
This indicates that the temperature of the chilled water is within the usable
temperature range.
Flashing slowly :
This indicates that the chilled water is not at the right temperature. Wait
up to 20 minutes. When the chilled water is at the right temperature,
the light will stop flashing. Note: The HydroTap is designed to
dispense chilled water in the temperature range 5°C to 10°C.
During heavy usage, the temperature can rise out of this range.
Red Boiling Water Light
On all the time:
This indicates that the boiling water is ready.
Flashing slowly :
This indicates that the boiling water is below usable
temperature.
Filter Change Light Off:
This indicates the filter
is operating within its normal specified life span.
Filter Change Light Flashing slowly :
The light will flash slowly when the
filter is due for replacement and the LCD will show “Filter Change”. Refer to
“Replacing the filter” section of this document.
Boiling Water Lever
Depressing the “Red” lever allows dispensing of Boiling water.
Pulling up the Red lever allows the tap to operate in a “no-touch” mode. Water
will flow
from between 5 and 15 seconds (This is user adjustable). To reset,
return the handle to the “Off” position and repeat the step. The lever has to be
manually returned to the “Off” position.
Chilled Water Lever
Depressing the “Blue” lever allows dispensing of Chilled water.
Pulling up the Blue lever allows the tap to operate in a “no-touch” mode.
Water will flow from between 5 and 15 seconds (This is user adjustable). To
reset, return the handle to the “Off” position and repeat the step. The lever has
to be manually returned to the “Off” position.
Safety Lock
The safety lock is designed to prevent the flow of boiling water, if the hot lever
is inadvertently activated.
To operate when lock is ON,
depress both the Red lever and the safety lock
simultaneously.
Note:
On the Boiling only models
the Chilled LED is blank.
Boiling
Chilled
Filter Change
Safety Lock
Operating the HydroTap
Press or pull lever
