HydroTap Installation and Operating Instructions_Commercial_BCH 4in1_BH 3in1_October 2012_V1.05
Page 16 of 24
These instructions must be read in conjunction with the fi lter fi tting
instructions supplied with the high performance fi lter kit.
Depending on local water quality conditions and usage, the filter will require
changing when it has reached its rated capacity. You may also need to replace
the filter if you notice unpleasant odours or tastes.
To change the pre-set filter life, scroll through the menu to “External Filter
Life”, press adjust
>
to reset litre counter. Press adjust
>
and it asks “are
you sure”. Press adjust
>
again to lock in the command.
To Change the external filter:
1. Scroll through the screen menu to “Filter Flush Off” this isolates the water
supply.
2. Relieve system pressure by lifting the Hot lever and allowing the water to
run until it shuts off automatically (15 secs.)
3. Remove and replace the spent external filter cartridge as described in the
filter kit instructions. Mop up any spills from the filter head.
4. Scroll through the menu to “External Filter Used”, press adjust
>
to reset
the litres. Press adjust
>
and it asks “are you sure”. Press adjust
>
again to lock in the command. After approx 10 seconds it will default to
the selected mode.
The Zip HydroTap notifies when filter replacement is due. The default setting
is 6000 litres, but this can be set in increments of 1000 litres from 1000 litres
to 10000 litres. When a filter change is due, the Change Filter light will flash
white once a minute and remain so until reset. A filter status light is located
between the Red and Blue Lights on the tap head assembly.
Depending on local water quality conditions and usage, the filter may require
changing anywhere from 1000 litres to 10000 ltres. You may also need to
replace the filter if you notice unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement. Keep a
bucket and towel handy to catch drips and mop up any spills.
To change the Filter:
1. Scroll through the screen menu to “Filter Flush Off” this isolates the water
supply.
2. Open the left door
3. Relieve system pressure via the filter flush stop cock, a quick open and
close will do.
4. Grasp filter cartridge and twist right to left one quarter turn until it stops.
5. Ease cartridge downwards to detach it from the filter head (socket).
6. Do not tilt the cartridge as dirty water may spill from it if tilted.
7. Unpack replacement cartridge and write today’s date where shown on the
label.
External Filter Replacement
HydroTap filter location
Internal Filter Replacement
Boiling Unit - filter location
