INSTALLATION AND OPERATING INSTRUCTIONS:
Manual tool changers, HWR series
7
DDOC001
12 / h
EN / 2020-01-15
Zimmer GmbH
●
Im Salmenkopf 5
●
77866 Rheinau, Germany
●
+49 7844 9138 0
●
+49 7844 9138 80
●
www.zimmer-group.com
7. Installation
NOTICE:
Switch off the power supply before any assembly, installation or maintenance work.
CAUTION:
Switch off the power supply before any assembly, installation or maintenance work.
► Switch off the power supply before all work.
► Switch off the power supply to the machine or the system before all work.
►
Secure the power supply against being switched on unintentionally.
►
Check the power supply for any residual energy.
WARNING:
Risk of injury in the event of unexpected movement of the machine or system into which the tool changer
is to be installed.
► Switch off the power supply to the machine before all work.
►
Secure the machine against being switched on unintentionally.
►
Check the machine for any residual energy.
7.1 General installation information
Ö
Screw-in depth ≥ 1.2xØ
Ö
The mounting screws are not included in the scope of delivery.
Ö
Strength class of the mounting screws ≥ 8.8 (DIN EN ISO 4762)
Ö
Observe the tightening torque of the mounting screws.
Ö
Make sure the mounting surface is sufficiently rigid and flat.
7.2 Installation of the mechanical system
Fixed part
1
:
► Insert cylinder screws in the designated fits
bm
on the
fixed part
1
.
► Installation from the fixed-part side, against the handling
system.
Loose part
3
:
► Insert cylinder screws in the designated tool fits.
►
Installation from the tool side, into the tapped holes
bn
of the loose part.
1
bm
3
bn
