INSTALLATION AND OPERATING INSTRUCTIONS:
Manual tool changers, HWR series
5
DDOC001
12 / h
EN / 2020-01-15
Zimmer GmbH
●
Im Salmenkopf 5
●
77866 Rheinau, Germany
●
+49 7844 9138 0
●
+49 7844 9138 80
●
www.zimmer-group.com
3. Proper use
NOTICE:
The tool changer is to be used only in its original state with its original accessories, without any unautho-
rized changes and within the scope of its defined parameters of use.
Zimmer GmbH shall accept no liability for any damage caused by improper use.
Use outside of the defined parameters is not permitted. Unauthorized mechanical modifications must not be made.
The tool changer is designed exclusively for manual operation.
The tool changer is properly used in closed rooms for handling and holding.
Direct contact with perishable goods/food is not permitted.
4.
Personnel qualification
Installation, commissioning and maintenance may only be performed by specialists. These personnel must have read
and understood the installation and operating instructions in full.
5. Product description
5.1 Forces and torques
INFORMATION:
For information on forces and torques, please visit our website.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
5.2 Type plate
A type plate is attached to the housing of the tool changer.
The confirmation number and the article number are shown on this type
plate.
► The confirmation number should be assigned to the project.
Ö
Article number:
dl
Ö
Confirmation number:
dm
INFORMATION:
Please state the confirmation number in the event of damage or a complaint.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
