16 ZIG-POE-AHTX USER MANUAL
Device Name & Notes
Device Name
– default out of the box is ZIG-POE-AHTX
[n9]
.XXXX (last 4
digits of the serial number). You should change it if you are using more
than 1 device (Change Name below) to whatever you want
– ex.
CR100RX
– for conference room number 100 receiver.
Notes
– free form field for entering installer notes.
Control/Defaults (RS-232 Command Lines)
Button Press
– enter the command for the CMD button – use Test and
Save buttons to make sure it works and saved.
HDMI Cable Connect
– enter the command that you want to have
executed when an HDMI cable is plugged into the wall plate. Use Test and
Save buttons to make sure it works and saved.
HDMI Cable Disconnect
– enter the command that you want to have
executed when an HDMI cable is unplugged from the wall plate. Use Test
and Save buttons to make sure it works and saved.
VGA Cable Connect
– enter the command that you want to have executed
when a VGA cable is plugged into the wall plate. Use Test and Save
buttons to make sure it works and saved.
VGA Cable Disconnect
– enter the command that you want to have
executed when a VGA cable is unplugged from the wall plate. Use Test
and Save buttons to make sure it works and saved.
NOTE: When assigning and programming via the WebOS you can also
use escape characters
– line feed \n and carriage return \r
Firmware/Reset/Info
Serial Number
– serial number of AHTX
Firmware
– Current firmware revision
Hardware
– for internal use
IP Address
– IP address of the unit assigned by your DHCP Server
Device Name
– this is what you want to call the unit – syntax example
CR100RX_k123. This is also the name you type into your browser to
access the WebOS.
Factory Reboot
– Will reboot the unit.