12 ZIG-POE-AHTX USER MANUAL
General
– In the example above we are showing using an HDBaseT transmitter
(ZIG-POE-AHTX) connected to the HDBaseT receiver (ZIG-POE-RXAV)
– as
mentioned previously you also get an amplified audio output for direct connection
to speakers, LAN ports for almost anything you choose and for controlling/setting
up the devices, relays, a 4K scaler and IR and RS232 control and functionality.
1. Connect sources to ZIG-POE-AHTX
– HDMI, VGA and Composite – with
audio if required.
2. Connect RXAV to Display via HDMI
3. Connect Ethernet cable between HDBaseT transmitter (ZIG-POE-AHTX)
and RXAV (HDBaseT) Ports
– this will also provide power on the ZIG-
POE-AHTX
4. Note: If you are not using ZIG-POE-RXAV you can also connect directly to
the HDBaseT port on the back of the unit to access/program it.
5. Connect LAN switch/router to LAN 1 port
– this is the switch or router that
issues IP address (DHCP server)
6. Connect your PC or MAC to the same switch/router. The DHCP server will
issue IP addresses to both devices separately.
7. Turn on the Source, TV and RXAV
8.
Locate the serial number sticker on each RXAV and make note of it. The
web address for the given unit is
http://rxav-xxxx/
where the xxxx are the
last 4 digits of the serial number. Ex. If the serial number is
154320000015, then the web address is
http://rxav-0015/
. This is
necessary to distinguish multiple units from colliding in the network before
their names are changed by the customer. The ZIG-POE-AHTX operates
similarly...i.e.
http://poewp-xxxx/
.
[n8]
9. You can also locate the devices with Bonjour. If you do need to connect
directly from a PC or Mac to the LAN 1 or 2 port in the RXAV without a
router (LAN) you can expect up to 5 minutes for the address to be
resolved.
10. Once connected the user interfaces will be available for you to evaluate,
change, enter commands, etc.
