10 ZIG-POE-AHTX USER MANUAL
Typical IR Application Above
8. IR Out port
– (Tip P+, Ring P-) 3.5mm – this can be used to send IR to
local sources
– the origin of the signals would be from the connected
HDBaseT RX device (like ZIG-POE-RXAV IR routing)
9. IR In port
– 3-13 V 3.5mm
[n6]
(Tip Signal, Sleeve Ground)
– connect IR
sensor if you don’t have line of site to the built-in IR sensor. Place
black tape over built-in sensor when this port is used to eliminate
interference.
10. LAN (RJ45) port
– Full WebOS control for channel switching. Port can
also be used to access and control any HDBaseT device on the
network. Telnet and direct HTTP requests
[n7]
are supported.
11. RS232 (9-pin) port
– Bi-directional for local control and remote control
(commands relayed via HDBaseT port. Local commands executed
locally.