913-326A
November 2005
GE
Sensing
Network Connection and
Factory Reset
Fieldbus network connections are made at J8, pins 1 and 2 (see Figure 1
below). Optionally, a shield can be connected to J8 pin 3, depending on
the network wiring.
No connections are made to J9 under normal operation. If it is desired to
reset the network board to factory defaults:
1.
Connect a jumper between J9 pin 2 and J9 pin 3.
2.
Power cycle the instrument.
3.
Ten seconds after the power has been restored to the unit, remove the
jumper to return the network board to normal operation.
Figure 1: Model XMT868 Rear View - Network Connection and Factory Reset
Foundation Fieldbus Communications for the XMT868
J8
J9
1
2
3
Field
bus
Ne
t (+
)
Field
bus
Ne
t (–
)
Op
tion
al S
hie
ld
J8
•
•
•
1
2
3
•
•
•
J9
RTN
Fac
tory
Re
set
N/C
