TR1200IP
12390-0706-05
Page
3 / 23
www.ziehl.de
1
General Notes
Compliance with the following instructions is mandatory to ensure the functionality and safety of the
product. If the following instructions given especially but not limited for general safety, transport,
storage, mounting, operating conditions, commissioning and disposal / recycling are not observed,
the product may not operate safely and may cause a hazard to the life and limb of users and third
parties.
Deviations from the following requirements may therefore lead both to the loss of the statutory
material defect liability rights and to the liability of the buyer for the product that has become unsafe
due to the deviation from the specifications.
2
Display and controls
1
LED relay status
(yellow)
OFF
Relay is released
ON
Relay operating
2
LEDs sensors
(yellow)
ON
Sensor value of the related LED in the digital display
FLASHES,
8
Er1
8
or
8
Er2
8
Sensor error in the corresponding sensor circuit
MORE THAN ONE ON
Temperature value of the warmest sensor is displayed in the
digital display
3
3-digit digital display
(red)
Displays the sensor value
Displays the errors with error code e.g.
8
Er 9
8
4
Last decimal point
(red)
Off
Display mode
Illuminated
Menu mode
Flashes
Configuration mode
5
LED Error
(red)
OFF
No error present
ON,
8
Er1
8
,
8
Er2
8
,
8
Er8
8
or
8
Er9
8
Sensor error, device error or configuration error
6
Up / Down key
(in display mode, normal state)
Press briefly
Change into the menu mode
Press for > 2s:
Displays the MAX (Up) and MIN (Down) measurement, pressing the
Set key for ≥ 2s in addition deletes the saved value
7
Set/Reset key
(in display mode, normal state)
Press briefly
Displays the next measurement
Press for > 2s:
Reset, return to display mode
Press for > 10s:
Displays the software version e.g.
8
000
8
8
Ethernet interface LEDs
(yellow)
Act FLASHES
BRIEFLY
Unit is receiving or transmitting via the Ethernet interface
Link FLASHES
BRIEFLY
Valid connection via the Ethernet interface
