OPERATION
39
6.2 Commissioning
Fig. 48
Working angle (basic setting)
If larger or smaller tires than the standard equip-
ment are mounted on the harvester, it is advisable
to check the working angle. The same also applies
when using caterpillar tracks.
The check should preferably be carried out under
real operating conditions in the field with the usual
ground clearance.
For a correct working angle, ensure that B must be
around 18-20 cm when the corn head is attached to
the combine and the front slides A are placed on
the ground. Otherwise, you will have to move the
attachment position C of the attack. See below.
The corn head equipped with a stubble chopper is
designed to cut at a height of between 10 and 12
cm from the ground.
Fig. 49
Rotation speed
The standard rotation speed is set at n= 580-630
U/1
min.
Safety dictates that a rotation speed of 700 U/1 min.
may not be exceeded.
To ensure a sufficiently favourable rotation speed ra-
tio, the rotation speed of 550 U/1 min. may not be
exceeded with the harvesting of corn.
Subsequent damage resulting from failure to comply
with the rotation speed range is not covered by the
guarantee.
Fig. 50
Testing the lateral inclination compensation
Check the function of the angling blade in the har-
vester in connection with the cornheader before com-
missioning.
•
Check the drive shaft for sufficient cover.
•
Check the sidehill control (optional)
No persons are permitted to be present in
the danger area when the machine is run-
ning.
