DKC400(U) & DKC400(U)Y SLIDING GATE OPERATOR USER’S MANUAL
Button switch
keypad
Not used
G
T
COM
K
Com
Signal
NO
com
K
Open
G
com
NO
Control board
Schematic diagram
Wiring diagram
NOTE: Two modes (three-button mode or single-button mode) you can select according
to your order.
15. Output power supply: +12V (DC +12V), COM (CO)
，
DET (Loop detector), I.R. (Infrared
N.C)
DET
COM
Out
COM
AC24V
AC24V
Terminal
X5,No.11
Loop detector
Control board
Loop detector with AC input
COM
GND
+12V
Out
COM
DET
COM
+12V
Loop detector
Control board
Loop detector with DC input
Infrared with AC input
Infrared with DC input
Control board
Infrared
Control board
Infrared
Terminal
X5,No.11
AC24V
AC24V
COM
Out
COM
I.R
+12V
COM
I.R
COM
Out
+12V
GND
COM
Terminal
X8, No.15
Terminal
X8, No.15
Terminal
X8, No.15
Terminal
X8, No.15
Schematic diagram
16.
Beeper: DC12V
17.
Learn button: AN
18.
Dip-switch
19.
Antenna: ANT
19
DKC400(U) & DKC400(U)Y SLIDING GATE OPERATOR USER’S MANUAL
8. Control
Below are all of the available remote controls for DKC400 series gate operators, the remote
control came with your operator depends on your order.
Additional remote controls can be purchased through your dealer.
Fig.17
You can select program / learn process (supporting up 100 remote controls or 25
remote controls) according to your order. If you have any problem, please contact the
dealer.
Adding extra remote controls (learn): Press the button ‘AN’ (See Fig.14, Fig.15 terminal
13 or Fig.16 terminal 17) on the control board, then the ‘LED2’ will be on and turn off,
the beeper will ring about 1 second, then press the remote control button which you
want to use, the beeper will ring about 2 seconds and the ‘LED2’ will turn on and then
turn off, The learning process is finished.
Up to 100 remote controls may be used.
Adding extra remote controls (learn): press the button “AN” (See Fig.14, Fig.15 terminal
13 or Fig.16 terminal 17) on the control board, then the beeper will ring about 1 second,
when you press the remote control button, the beeper will ring again, press the same
remote control button again, the beeper will ring at 1/2Hz frequency and then stop. The
learning process is finished.
Up to 25 remote controls may be used.
Erase remote controls: To erase all existing remote controls, press and hold ‘AN’
button until the beeper stops ringing. This indicates that all the remote controls have
been erased completely.
Warning: For safety and security, we recommend that the factory setting be
replaced with a personal code.
The remote control works in a single channel mode. It has four buttons. See Fig.17
The function of button 1, button 2 and button3 are the same. With each press of the
remote control button which has been programmed, the gate will close, stop, open or
20
YKF09
YKF06
Button 4
Button 3
Button 2
Button 1
Button 3
Button 4
Button 2
Button 1
