DKC400(U) & DKC400(U)Y SLIDING GATE OPERATOR USER’S MANUAL
7. Connecting ----DKC400(U)Y
Make sure that the power is OFF before making any electrical connections.
Control board included in the gate operator, there are three different types of control boards
can be used for the gate operator, select the proper board diagram according to your order.
Perform the wiring (See Fig.14 KZB01 control board with SCR, Fig.15 KZB05 control board
with relay or Fig.16 KZB13 control board with SCR & relay.)
Fig.14 KZB01 control board with silicon controlled rectifier
11
DKC400(U) & DKC400(U)Y SLIDING GATE OPERATOR USER’S MANUAL
Wiring notes for control board (KZB01)
1.
Power switch: ON/OFF
2.
Fuse: DKC400Y/XF24W: 5A, Ø5x20; DKC400UY/XF24U: 10A, Ø5x20
3.
Antenna: ANT
4.
Beeper: DC12V
5.
Dip-switch
6.
Memory Card: 93C66
7.
MCU: PIC 16C57C
8.
Three button switch / single button switch (keypad):
Three button switch (normally open, three-button mode): T (Stop), G (Close), K (Open),
COM (Common)
N.O.
Button switch
Control board
terminal X10 No.8
T
G
K
COM
COMMON
STOP
CLOSE
OPEN
COM
T
G
K
Schematic diagram
Wiring diagram
Single button switch / Keypad (normally open, single-button mode): T (Not used), G
(Open priority), K (Open/stop/close), COM (Common)
To install the keypad attach one lead of your keypad to ‘K’ of terminal X10 and the other
to the ‘COM’. The keypad will function in single channel mode.
Button switch
keypad
Not used
G
T
COM
K
Com
Signal
NO
com
K
Open
G
com
NO
Control board
terminal X10 No.8
Schematic diagram
Wiring diagram
NOTE: Two modes (three-button mode or single-button mode) you can select according
to your order.
12
