Section 4. Programming
4-3
02#
______#
Disconnect Code 1 - 9 digits (0 to 9, and #)
#1
03#
______#
Toll Restrict Bypass Code 1 - 8 digits (0 - 9, *)
99
Note: Some thought must be given to programming new access codes into the
Model 30. It is best to avoid using one access code that is a direct sub-set
of another code. For instance, if a single “*” is used for the Connect
Code, then a “*” cannot be used as the first character of the Toll
Restrict Bypass Code (e.g. “*2”). Programming the unit this way would
result in the patch never recognizing the Toll Restrict Bypass.
Mobile-to-Phone Pulse or DTMF Dialing
These two commands select the dialing method that is used to place mobile-to-
phone calls.
04#
DTMF Regenerate Mobile Originated Calls
D
05#
Pulse Dial Mobile Originated Calls
Number of Rings-to-Answer
This command sets the number of rings that must occur on the phone line before
the Model 30 will start ringing on the channel, or answer the line to prompt for a
capcode.
06#
___#
Rings-to-Answer (1 to 10 rings)
1
Single Digit Access Code Validation
When enabled, this feature requires that the single digit access codes be held for
a minimum of 0.5 seconds. This digit-timing minimum only applies to access
codes that are programmed for a single digit. Multiple-digit access codes do not
have any minimum digit timing limit. This command applies to the connect code,
disconnect code, toll restrict bypass code, as well as the auxiliary output on/off
codes.
09#
___#
Single Digit Access Code Validation
(0 = Disabled, 1 = Enabled)
1
Dial Regeneration Timeout Timer
This timer applies whenever a mobile user is dialing a phone number. This
command sets the maximum amount of time the phone patch waits between
DTMF digits received from the mobile before dropping out of the regeneration
mode. A DTMF “*” can be used to manually terminate the regeneration mode.
Because of this, it may be preferred to set the regeneration time longer. Used in
this way, a more comfortable dialing speed can be maintained while still
remaining in regeneration as long as needed.
Содержание 30 Worldpatch
