ZETRON 30 Worldpatch, Инструкция по эксплуатации

Страница: 15 / 60

Section 3. Operation
3-3
3. Dial Tone Disconnect - If continuous dial tone is detected after the
conversation mode of a call has begun, the call will be terminated and 5 fast
beeps sent to the mobile. This feature may be disabled by the installer.
4. Mobile Activity - The mobile must transmit at least once during the mobile
activity interval. If not, the call will be terminated and the 5 fast beeps will
be sent to the mobile. During the conversation, a single beep will be sent to
the phone and the mobile every 3 seconds starting at 12 seconds before the
mobile activity timer expires. This beep serves as a warning to both the
telephone user and the mobile user.
5. Call Limit - Each call is limited in length. Once the call limit timer has
expired, the call is terminated and 5 fast beeps are sent to the mobile.
Double warning beeps are sent to the telephone and mobile every 3 seconds
starting 15 seconds before the call limit timer expires. If programmed to do
so, the Model 30 may allow the mobile to extend the call limit time by
pressing the “*” key.
6. Phone Party Disconnect - The phone party may disconnect the call by
entering a DTMF “#0”. The call will then disconnect in the same manner as
if the mobile had initiated the disconnect.
7. Connect Button - Pressing the connect button while the Model 30 is off-
hook terminates the call in progress and forces the Model 30 back into the
on-hook idle mode.
Remote Programming Access
The mobile user may enter the program access code to gain access to remote
programming.
MODEL 30 FEATURES
DTMF or Pulse Dial Regeneration
The Model 30 defaults to regenerating the DTMF digits received from the mobile
user to dial the telephone. This allows the unit to present a pre-set level and
quality of DTMF to the phone line regardless of conditions on the channel. This
function can also be programmed to translate the mobile’s DTMF into pulse
dialing, should that be required by the connected telephone service.
While dial regeneration is active, audio from the mobile unit connected to the
system is not passed to the telephone line.
Dialed number regeneration is a timed function. By default, the mobile user has 3
seconds to dial each digit of the phone number. This time may be programmed to
be from 0 to 60 seconds. Regeneration time must end before conversation can
take place. This can either be done by waiting until the regeneration timer lapses