ZETRON 30 Worldpatch, Инструкция по эксплуатации

Страница: 22 / 60

Section 4. Programming
4-2
programming, a key must be depressed every 60 second, or the Model 30 will
automatically exit the program mode, returning to normal operation.
The Model 30 offers no method of viewing the programmed settings (there is no
RS-232 port for CRT or printer.) As such, it is important to be careful during
programming and to keep track of all programmed settings. If the Model 30 is in
an unknown programming state, the settings may be reset to the factory defaults
from the front panel or by using a DTMF command. Care should be exercised
when resetting the unit if existing Model 30 users are expecting certain access
and disconnect codes.
To force the Model 30 to reset its programming to default values, from the front
panel, complete the following steps:
1. Turn off power to the Model 30.
2. Press and hold the Connect button.
3. While holding the button in, turn on the power to the Model 30.
4. Hold the Connect button until the phone light starts blinking (about 4
seconds), then release the button.
The Model 30 should now be reset to default values.
PROGRAMMING COMMANDS
A number of new programming commands have been added to allow the paging
to be tailored to the systems needs. In order to fit these commands into the Model
30, several changes were made to existing commands. These changes consolidate
and regroup several of the existing commands into a more logical structure. More
commands now use a “Command-#, Data-#” format. Programmers should find
these commands easy to use.
The data portion of these commands may be from one to several digits in length.
The length is determined by the range of allowable values or the maximum string
length in the case of passwords. With the exception of the program access code
(this must always be 5 digits), the data entered only needs to be as many digits as
necessary. For instance, if the allowable range for a value is 1 to 999 and the data
to be programmed is 6, the programmer may enter: 6, 06 or 006. In the following
list of commands, the default setting for each command is shown in the far right-
hand column.
Access and Disconnect Codes
In order to initiate and terminate phone calls, a mobile user must send a DTMF
access code. In all three cases the “#” character is used to terminate both the
command and the data string that follows it. In the case of the Disconnect code,
the “*” is used to specify a “#”. The “#” character terminates the command.
01# ______# Connect Code 1 - 9 digits (0 to 9, and *) *1