ZETRON 15P, Руководство по эксплуатации

Страница: 73 / 124

Section 5. Programming
5-25
Programming Example
This example assumes no prior knowledge of the Model 15P. You will be taken from power
up to programming. At the end of this exercise you will have programmed and edited two
Custom DTMF capcodes and their data. The encoder will be programmed with the
following:
Capcode DTMF ON OFF
1 893 # # # # DD3 20 20
2 893 # # # # DD4 20 20
Before beginning this exercise insure that a 12VAC wall transformer is properly connected
to pins 1 and 2 of TB1. See “ELECTRICAL SPECIFICATIONS” in Section 2 for the proper
wall transformer. Table 5-24 shows the required steps for programming the first page.
Table 5-24 Custom DTMF Example Page #1
Display Keystrokes Explanation
##### Plug in the wall transformer. Display shows Z-number & version
number during power up.
2.1 Version 2.1
SEtUP SEtUP means no formats programmed yet. You will see a single
dash if a format has been programmed.
ConFIG C+CLEAR
keys together Display momentarily shows ConFiG to indicate that it is entering
programming mode.
diGt= 0 0 to D ,
ENTER Select the leading digit. This digit identifies the format you are
programming. (Note: select an unused digit yet).
dELEtE PAGE, PAGE,
... PAGE key steps through the format selection menu . Press PAGE
key until Cdtn.F appears in the display.
Cdtn.f ENTER Select the Custom DTMF format.
C 1 Type in 1 for the capcode.
C 1 ENTER Press ENTER to input the capcode.
dtn.f 893####DD3 Type in 893####DD3 for the DTMF string.
###dd3 ENTER Press ENTER to input the DTMF string. (The “903” has scrolled of
the left end of the display.)
On 40 20 Type in 20 ms for the DTMF tone on duration.
On 20 ENTER Press ENTER to input the on duration.
Off 40 20 Type in 20 ms for the DTMF tone off duration.
Off 20 ENTER Press ENTER to input the off duration.
C Ready for next capcode.