zerona Z6, Руководство пользователя

Страница: 19 / 44

ZERONA Z6 OTC OVERVIEW & ASSEMBLY | 14
ASSEMBLY DIRECTIONS (CONTINUED)
WARNING-SHOCK HAZARD
To avoid risk of electric shock, ensure that the electrical power cord is disconnected
from electric supply when connecting electrical connector.

Insert the two halves of the electrical connection
[10] together by aligning the yellow markings
slightly pushing the outlet into the inlet as shown.

Twist the ring on the connector clockwise until it
can no longer be tightened to make sure it is secure.
This is important so that the two halves do not
separate while within the device.

Place the connector and cable inside the upright
base shaft and secure the cover.

Now that the laser has been put together, insert the electrical power cord [12] into the power
inlet [8] located at touch screen side of the base device. See figure 1.

Plug the electrical power cord [12] into any standard electrical outlet for your country/region.
The device includes a transformer which converts AC power to match the power output (i.e.
110V or 240V). Only a 3-plug prong adaptor is required. Once the adaptor is fixed to the plug
end, insert it into the wall socket. Disconnecting this cord while the machine is in operation
will stop the machine, so this can be used as a second or emergency turnoff.
WARNING-SHOCK HAZARD
To avoid risk of electric shock, make certain that the device is grounded by connecting
only to a grounded electrical socket (3-prong) conforming to the applicable national and
local electrical codes.