10
ZEPRESSO TREND INSTRUCTION MANUAL
11
ZEPRESSO TREND INSTRUCTION MANUAL
Programming
ATTENTION:
The appliance’s factory settings are programmed to:
• Hot beverage (1): 50ml
• Hot beverage (2): 120ml
• Cold beverage (3): 120ml
If you want to reprogram these settings please follow these instructions.
3.
Close the handle (A)
to load the capsule.
NOTE:
The programmable volumes range from 25 ml up to 800 ml.
'&#/#/6'&#/;#A"/J>M$
4.
Place an empty cup
under the dispenser (C).
5.
Pull down the dispenser
(C) if necessary.
6.
Push the desired button
(1-4) you want to program
and keep it pushed for
at least 8 seconds. Once
the desired volume has
been reached, release the
button. Now the button
is reprogrammed.
1.
Make sure there is enough
water in the water tank ( J).
2.
Open the handle (A)
and put a capsule
into the appliance.
IMPORTANT! Flushing out the appliance
Before using ZEPRESSO TREND for the first time the appliance
must be flushed out to clean the internal piping thoroughly.
CAUTION:
Beware of hot water and steam! Risk of scalding!
ATTENTION:
This process only works when the appliance is completely empty of water.
To flush the piping after use we recommend using the ‘Steaming out Function’ (See Page 17).
4.
Push any button (1-4).
The pump starts, the
indicator turns blue and
all buttons (1-4) light up.
5.
Place a large container
(250 ml or more) under
the dispenser (C).
6.
Push button (3) to start
the flushing process. The
flushing process stops
automatically.
1.
Turn on the main
switch (G).
2.
Fill the water tank ( J) to
MAXIMUM with cold water.
3.
Open and close
the handle (A).
