ZT MK2
Installation
23
www.zepro.com
4.4
Lift platform
1. Check that all included components are clean,
clean where necessary.
2. Lubricate the 1st booms’ metal bushings. Make
sure that the small holes on the inside of the
bushing are filled with grease. Use LE lubricant
4622.
3. Fit the platform to the arms using the supplied
shafts and screws. Tighten the screws.
Tightening torque: 80 Nm.
4. Fit one of the tilting cylinders to the platform. Use
the enclosed shaft and screw. Tighten the screw.
Tightening torque: 80 Nm.
NOTE!
Make sure the cylinder is installed with the grease nip-
ple facing up.
5.
Fit the support wheel on the shaft. Secure with
associated split pin.
NOTE
!
Lubricate the bushings before installation.
Picture 28. Take care to provide initial lu-
brication to the metal bushings
Picture 29. Fitting the platform to the arms
Picture 30. Fitting the tilt cylinder to the platform
