ZT MK2
Installation
21
www.zepro.com
4.2
Setting the work position
If necessary, the working position of the tail lift can be adjusted forwards (max. 55 mm). The adjustment option
can be extended by installing a longer adjustment screw (M12). However, the screw should be no longer than
150 mm. which allows adjustment up to approx. 125 mm. If further adjustment is needed, see section 4.3.
Comment
The space for adjusting the working position forwards is limited by the length of the platform. Make sure the platform can
be unfolded into the intended working position after installation.
1.
Unscrew the rear end caps on both slide profiles.
2. Loosen the adjusting screws’ counter-nuts.
3. Adjust the lift to the correct working position using the adjusting screws.
IMPORTANT!
Make sure the adjustment is the same on the left and right sides.
4. Lock the adjustment by tightening the counter-nuts.
5.
Screw the end caps on to both slide profiles.
Picture 25.
Slide profile end cap
Picture 26. Screw for setting the work position
