Zepro ZS 150-135, Инструкция по установке

Страница: 20 / 62

20
ZS
ZD
ZSS
ZTS
ZT
O
O
O
O
O
4. Slider installation
Attention! Also refer to the truck manufacturer´s instructions for auxiliary equipment
IMPORTANT: Finding the installation position of the
slider is very simple if these instructions are follo-
wed.
The platform and lift arm combinations described on
this page are optimised for minimum total over-
hang (O) , therefore always install the slide profile
rear edge level with the rear edge of the vehicle
frame or tow hook device so that the platform
can fold out .
If the slide frame is placed further forward there is a
risk (particularly for low ground clearance) that the
platform will not be able to fold out. There are only
two solutions. Either to move the slide frame to the
position that we recommend or choose a different
platform combination, but the new platform would
have shorter first and second folding part (and hence
perhaps be too short for your needs).
With these short overhang models the working posi-
tion is not the same as the folding out position.
Make the cut-outs as required in the rear beam in
accordance with the measures on previous pages.