Zepro Z 150-135, Инструкция по установке

Страница: 36 / 38

36
Max 2º
Max 15 mm
B
D
C
A
B
D
C
A
12. Load testing the tail lift
Testing and verification of the tail lift.
Carried out in accordance with the installation in-
struction and delivery check list.
Check that the tail lift chosen corresponds to the
vehicle and to its foreseen use.
Static loading test
To be carried out when installation is complete.
Deformation
Position the tail lift with the platform horizontal about
half way between the ground and the vehicle floor.
Measure the distances A,B,C,D as shown in the
diagram. Place a test load on the platform according
to the table (for the corresponding tail lift model and
loading capacity). Remove the load from the
platform. Repeat the measurements of A,B,C,D and
check that there is no permanent deformation to the
tail lift or its brackets.
Deflection
Place a test load on the platform according to the
table (for the corresponding tail lift model and loading
capacity). The tail lift should be in the same level and
angle as floor. Leave the test load on the platform for
15 minutes. Check that the platform´s deflection is
not more than 15mm vertically (point A and D) and
that it is not more than 2º in angular deflection (point
b and C), in relation to floor level.
Static loading (Test load 1,25 x tail lift loading
capacity). For tail lifts with load centre of 600 mm
Static loading (Test load 1,25 x tail lift loading
capacity). For tail lifts with load centre of 750 mm
Floor level
Capacity Load 500 kg Load 1000 kg
Distance out in platform (L)
450 kg (450 kg) 675 mm -
500 kg 750 mm -
700 kg 1050 mm -
750 kg 1125 mm -
1000 kg 1450 mm 750 mm
1500 kg 2250 mm 1125 mm
2000 kg - 1550 mm
2500 kg - 1875 mm
Capacity Load 1000 kg Load 1500 kg
Distance out in platform (L)
1000 kg 940 mm -
1500 kg 1410 mm 940 mm
2000 kg 1875 mm 1250 mm
2500 kg 2340 mm 1560 mm
Deformation
Deflection