Zepro Z 150-135, Инструкция по установке

Страница: 22 / 38

22
Information codes
Identification Code 1 Code
2
Code
3
Information Other
P
(Program
configuration)
00–99 Cancelled configuration
-
Dividers
12/24 Number of volts detected
J
Software version
01–99
Version number
1.-7 (Fixed light)
Active control device
while operating
1-7
Fixed light (1-7) displays active control
device during operation.
B
C
E X
In
Out
Segment
B, C, E
or X.
Segments B, C, E or X are illuminated de-
pending on which button is pressed
1-7 (Flashing)
The control device
that the control sys-
tem is locked for for
a while after opera-
tion completed.
1-7
Control device the control system is locked
for.
This primarily applies to radio and coil con-
trol devices as other control devices have
such a short locking period that there is no
time to see the indication.
The number will stop flashing when one of
the current control device's buttons are pressed.
If the control card has been without voltage
and receives the voltage again when the CS
(cabin switch) is switched on, "7" will flash on
the display and the control card is locked until
the Off/On on the CS is operated.
C
Sensor indication
Segment
1-6 segments indicate sensors.
On - signal in.
Off -no signal in.
(See electrical and hydraulics diagrams
for information about the location of the
sensors).
Di1 Di3
Di6 Di4
Di2
Di5
Example of sequence of information codes:
Program configuration: 01, Voltage detected: 12V, Software version: 02
7. Connection unit