Zepro Z 150-135, Инструкция по установке

Страница: 27 / 38

27
max 100 mm
min 350 cm
2
max 25 mm max 25 mm
133
193
241
301
617
667
717
767
2x M12x100 8.8
80 Nm
2x M12x80 8.8
80 Nm
817
2x M12x80 8.8
80 Nm
2x M12x100 8.8
80 Nm
8. Installation, continued
Installation of adjustable 3 parts bumper bar
Install the bumper bar temporarily. Check that it
is positioned within applicable dimensions. Max
550 mm between bar and ground when vehicle is
unloaded. Maximum 375 mm horizontally from the
outermost part of the lift platform to the bumper bar.
( pict 5 ). The inner brackets can be adjusted to 4
different height positions ( pict 6 ).
The outer brackets can be adjusted to 5 different
horizontal positions ( pict 6-1 ).
The lateral distance between bumper bar and
moving parts of the tail lift must not exceed 25
mm. The bumper bar must, in each case, have an
effective surface area of at least 350cm
2
(pict 7) .
The bumper bar can be positioned further back and
lower than the given dimensions. Where appropriate
check for place required for ring feeder, draw bar and
bracketry.
When the correct positioning is decided, connect all
brackets ( pict 8 ). Inner brackets is connected with
M12x100. Outer brackets is connected with M12x80.
Install brackets end covers with logo upright.
Pict. 8
Pict. 5
Pict. 7
Pict. 6 Pict. 6-1